Google News article A wall in your home could be illuminated with a simple illumination project.

If you’ve ever had a Christmas tree illuminated with lights in your front yard, then you know how easy it is to light it up for the season.

If not, here’s how to do it.

Read moreIf you’re looking to light up your home for the holidays, here are some ideas to get you started:You’ll need some basic lighting supplies for the project.

A candle or light bulb or two will do.

You’ll also need a lamp and a candle.

This project uses a basic LED lamp.

You’ll want to know how to attach the lights to the wall.

You can do this by putting the LED lamp in a box, like this, or by using the included adhesive strip.

You don’t need to use any special tools to attach these lights.

The LED lamp can be soldered onto the wall using the adhesive strip, and then the lights can be used to create a beautiful, illuminated wall.

Once you have your lights and the adhesive strips, the next step is to mount the lights onto the ceiling.

You should mount the LEDs on the wall in the order shown below.

Mounting the LEDs to the ceiling is easiest if you use the adhesive tape, because the adhesive is thicker than standard adhesive tape.

You also want to make sure that the adhesive doesn’t stick to the top or bottom of the LED lights, as this will damage the LEDs.

Once the adhesive has dried, you’ll need to mount these lights on the ceiling, which is a little tricky.

It’s easy to lose the adhesive.

To ensure a good finish, make sure to remove the adhesive and put it back on before you continue.

Here’s what it looks like when mounted on the left.

Mount the LEDs onto the top of the ceiling using the sticky adhesive.

Now, the last step is the easiest.

It requires only a couple of steps.

You need to cut out a rectangle that’s about the size of a football field and tape the LED to it with the sticky tape.

The adhesive should be slightly sticky to the adhesive, and this is where the glue comes in.

This is what it should look like:Now you’re ready to light your ceiling with the LEDs!

The trick is to use the sticky side of the adhesive to attach your LEDs to each other.

It should be sticky, so they won’t fall out of the lights, but they shouldn’t fall off.

Once you’re satisfied that everything is properly attached, the lights will light up.